Analysis Note

Positive ControlOSA-CL cells

Application

Frozen Sections (1-5 µg/ml, see application references) r>Immunoblotting (0.5-2 µg/ml, chemiluminescence) r>Immunofluorescence (1-5 µg/ml) r>Immunoprecipitation (1 µg/sample) r>Paraffin Sections (1-5 µg/ml, heat pre-treatment required, see application references)

General description

This Anti-MDM2 (Ab-1) Mouse mAb (IF2) is validated for use in Frozen Sections Immunoblotting Immunofluorescence Immunoprecipitation Paraffin Sections for the detection of MDM2 (Ab-1).

Recognizes the ~90 kDa (apparent MW) MDM2 protein. Also recognizes isoforms of ~57 kDa and ~74/76 kDa by immunoblotting.

Purified mouse monoclonal antibody (see application references). Recognizes the ~90 kDa (apparent MW) MDM2 protein. Also recognizes isoforms at ~57 and ~74/76 kDa.

Immunogen

human MDM2

Epitope: within amino acids 26-169 of human MDM2

Human

Legal Information

TWEEN is a registered trademark of Croda International PLC

CALBIOCHEM is a registered trademark of Merck KGaA, Darmstadt, Germany

Other Notes

Gorgoulis, V.G., et al. 1996. J. Pathol.180, 129.Marchetti, A., et al. 1995. J. Pathol.175, 31.Barak, Y., et al. 1993. EMBO J.12, 461.Ladanyi, M., et al. 1993. Cancer Res.53, 16.Leach, F.S., et al. 1993. Cancer Res.53, 2231.Oliner, J.D., et al. 1993. Nature362, 857.Momand, J., et al. 1992. Cell69, 1237.Oliner, J.D., et al. 1992. Nature358, 80.Fakharzadeh, S.S., et al. 1991. EMBO J. 10, 1565.

Although the amino acid sequence of MDM2 predicts a protein with a molecular mass of approximately 54 kDa, MDM2 protein migrates on SDS/PAGE with an apparent mobility of 90 kDa. r>r>Immunoblotting Protocolr>MDM2 (Ab-1) can be used to detect MDM2 by Western blot of proteins previously separated by SDS/PAGE and electrophoretically transferred onto nitrocellulose membranes. The proteins are reacted with the monoclonal antibody and visualized using an HRP conjugated goat anti-mouse antibody with chemiluminescent detection. r>r>Materialsr>Equipment:r> Electrophoresis apparatusr> Electroblotting apparatusr> Rocker platformr>r>Solutions and Reagentsr> Anti-MDM2 (Ab-1) Mouse mAb (IF2) Cat. No. OP46 or OP46Tr> HRP conjugated goat anti-mouse IgG heavy and light chains (e.g. Cat. No. 401215) r> Chemiluminescence detection systemr> ELB Buffer (include a cocktail of proetease inhibitors, such as 0.5 µg/ml leupeptin, 1 µg/ml pepstatin, 1 mM EDTA and 0.2 mM PMSF): 50 mM Hepes pH 7.0, 250 mM NaCl, 0.5 mM EDTA, 0.1% Nonidet P-40 Alternativer> SDS-PAGE (7% acrylamide)r> Phosphate buffered saline (PBS) pH 7.4; 1 Liter: 0.2 g KCl, 0.2 g KH₂PO₄, 8 g NaCl, 1.15 g Na₂HPO₄r> PBS/0.1% Tween^®-20 detergent (PBST)r> 3% Non-fat Dry Milk in PBSTr>r>Procedurer>1. Lyse cells in ELB Buffer. (Alternatively, cells can be lysed in RIPA Buffer or directly into 1x Laemmli Sample Buffer).r>2. Electrophorese 50-100 µg lysate using a 7% acrylamide gel. r>3. Transfer the protein samples from the polyacrylamide gel onto a nitrocellulose membrane using an electroblotting apparatus.r>4. Block the membrane for 1 h in PBST containing 3% non-fat dry milk at room temperature with rocking. Use about 1 ml per cm² of membrane.r>5. Incubate the membrane with 1 µg/ml Anti-MDM2 (Ab-1) Mouse mAb (IF2) in 3% non-fat dry milk/ PBST for 1 h at room temperature with rocking.r>6. Wash the membrane 3 times, 15 min each, in PBST at room temperature with rocking.r>7. Incubate the membrane with HRP conjugated goat anti-mouse IgG heavy and light chain antibody, diluted according to the supplier's instructions, in 3% non-fat dry milk/ PBST at room temperature for 1 h.r>8. Wash the membrane 4 times, 15 min each, in PBST at room temperature with rocking.r>9. Develop the membrane using chemiluminescent detection reagents according to manufacturer instructions.r>10. Expose the membrane to film for ten minutes. Adjust subsequent exposure times as needed.

Packaging

100 µg in Plastic ampoule

Please refer to vial label for lot-specific concentration.

Physical form

In 50 mM sodium phosphate buffer, 0.2% gelatin.

Warning

Toxicity: Standard Handling (A)